RP2350-based rubber ducky, firmware for https://github.com/Outdatedcandy92/PicoDucky

NOTE: The "load from USB" feature isn't working currently

• Modify duckyscript easily, mounted as a FAT flash drive

1. Short GPIO14 to GND
2. Flash the .uf2 onto a RPi Pico 2
3. Wait until it pops up as a USB drive (usually takes ~30s courtesy of horrible code design)
4. Edit the picoducky.txt file
5. Unplug and disconnect GPIO14
6. Done

Filesystem: FAT filesystem on top of LittleFS (for block wear levelling, realistically this isn't necessary but whatever). This is probably a better way of doing it