DEMO : https://youtu.be/F5pjVtjYKLo
I built this macropad to help with my productivity and improve my usage of macros , While I had built many complex project but never built a simpler one like this thats both economical and proactical in day today life
First, connect the wires as shown in the diagram below.
Make sure all connections match the diagram before powering on the microcontroller.
- Install CircuitPY
- Add KMK files
(KMK folder and boot.py) - Add the code.py firmware from the
FIRMWAREFolder - Disconnect and Reconnect
- Yayyy Hackpad works
| 3D Printed | Render |
|---|---|
 |
 |
| Item | Description | Quantity | Unit Cost (₹) | Total Cost (₹) | Notes |
|---|---|---|---|---|---|
| Jumper Wire | Assorted jumper wires | 1 set | 0 | 0 | Found in home storage |
| Waveshare RP2040 Clone | RP2040 Zero Raspberry Pi MCU with Presoldered Header | 1 | 299 | 299 | https://www.indianhobbycenter.com/products/rp2040-zero-raspberry-pi-mcu-with-presoldered-header?_pos=1&_psq=RP2040-Zero+Raspberry+Pi+MCU+With+Presoldered+Headerader |
| Printed Case | Custom 3D-printed enclosure | 1 | 0 | 0 | Printed myself |
| Akko black switches | Existing switches | 7 | 0 | 0 | Had them at home |
| Akko grey keycaps | Existing switches | 7 | 0 | 0 | Had them at home |
| USB _ C WIRE | Generic Wire | 1 set | 0 | 0 | Had them at home |
| Total | 299 |
