A 9 key 3 encoder macropad running on QMK firmware and a RP2040 MCU
Features:
- 3D printed shell
- Custom PCB
- LEDs
- All running on QMK firmware
- Change buttons, shortcuts, and LEDs from your browser on QMK
A 4 layer board
Built on the RP2040 integrated directly into the board with all the typical components you will see on a RP2040 dev board.
Schematics:
Fully 3D printed
Credits:
This firmware is based on open source code by Robert Feranec https://www.youtube.com/@RobertFeranec. i forked it with minimal modifications, but all the original code is from them. It runs on n QMK firmware, which is also open source.
3D file this for mr cyao