Racing sim Ebrake that has the same bolt pattern as the Moza!

I wanted an ebrake but all of the existing solutions either looked kind of boring or were extremely expensive (moza handbrake).

1. Press the handle and bottom piece onto the V slot aluminum

2. Mark and drill an 8mm hole through the bottom of the aluminum where the top hole in the plastic is
3. Wire the hall sensor and pro micro like this

5. Put the pro micro on the front after feeding the wires through the hole and secure it with tape or hot glue

6. Double sided tape the hall sensor here

9. Hot glue the magnets here

11. Press fit bearings in each side of the base

13. Put a rod through the bearings and shaft
14. Attach the spring pivot like this

16. Insert the spring here

18. Attach the side panels (optionally add the acrylic inserts)

1. Download the Xloader folder
2. Run the .exe
3. Click upload once you have selected the correct port and the correct hex file as according to the guide on ranebgs github