Clicksmith is a 3x3 macropad and it uses KMK firmware

I mostly built it because I just want a macropad laying around for macros and etc, that was my inspiration

For my challenges, I didn’t use Fusion 360 or KiCad at all before. In KiCad I got the hang of it pretty quick, but for Fusion 360 not so much. I googled so much and I personally think that it's a stupid piece of software, but I'm pretty proud of my self and my HackPad. The most difficult part for me was probably designing the case because as I mentioned before Fusion 360 is a stupid piece of software..

BOM:

• 9x Cherry MX Switches
• 2x SK6812 MINI Leds
• 1x XIAO RP2040
• 9x Blank DSA Keycaps
• 4x M3x16 Bolt
• 4x M3 Heatset

Others:

• KMK Firmware
• ClicksmithTop.step (This is the plate)
• ClicksmithBottom.step

Schematic PCB Case