Cyberpunk city/Sci fi city
Description
PDFIt is a cyberpunk/sci fi city with a particle accelerator in the middle here are all the things i recommend for a nice and safe print:
10% Gyroid Infill
Tree support do not use normal support!
This model is designed to print as a single tile on most modern FDM printers. It contains many recessed details (windows, signs, alleys) that do not require supports when printed with the recommended settings.
Please read this guide before printing to avoid failed long prints.
Well-tuned FDM printers
Tested on Bambu Lab A1
Works on most printers with good cooling
PLA recommended
Dry filament strongly advised
Avoid brittle or old filament for long prints
Layer Height
0.20 mm (recommended)
0.16 mm works if your printer is well tuned
Nozzle
0.4 mm (standard)
Print Speed
Use default or slightly slower speeds
Long prints benefit from reduced vibration
Walls: 3–4
Top / Bottom layers: 5–6
Infill: 10–15%
Gyroid or Cubic preferred
Buildings are designed as shells and do not need heavy infill.
Tree supports (or Organic supports)
Build plate only
60° recommended
Only a few supports should appear (e.g. under large bridges or balconies).
This is intentional.
Windows are recessed (~1 mm)
They print as short bridges
No supports are needed
Adding supports inside windows may damage details
If you see only a small number of supports, this is correct.
Brim strongly recommended
8–12 mm
Clean bed before printing
Watch the entire first layer
If the first layer does not adhere perfectly, stop and re-level.
If needed please check the bed level and pay attention to the first couple of layers!
Model origin
The author marked this model as their own original creation.
License
This work is licensed under a
Creative Commons (4.0 International License)Attribution
