.2mm layer height.
Outer brim for parts
slim tree supports for all but part labeled "Upper Frame" for that use regular snug supports.
To assemble take the bottom Chassis and attach the three axels by the pegs. Then attach the upper frame with the corresponding pegs and holes on both parts. The boon is attached to the back with a regular round rod and sits atop the cabin. The support arms slots into a part on the main base and the other part to a hole on the bottom of the boon. The winch is made up of a body two bearings and a rod with a gear at the end. push bearings into both ends of the winch and then push the rod into the holes on both, it should be able to freely spin now. Wheels pop onto the ends of axels and take a bit more force than expected. For the hook and winch you need to cut a length of TPU and tie it to the end of the hook. take the other end of the TPU "rope" and feed it through the holes in the winch rod and tie.
